WISP signal field checklist

Use your browser's Print command to print or save as PDF. Write on the printed sheet; nothing is submitted. Read the troubleshooting guide.

ISPAgents · Manual field worksheet · 16 October 2026 · ispagents.com/guides/wisp-signal-troubleshooting

1. Identify the fault

Ticket / subscriber / technician:

CPE / exact AP radio or interface / date, time and timezone:

2. Capture comparable readings

Models / firmware / band / frequency / width / active traffic:

Metric (timestamp at both ends)CPE before / afterAP before / after
Signal and per-chain levels (dBm)
Noise (dBm) / SNR (dB)
CCQ or named vendor quality / capacity (%)
TX/RX PHY rate / healthy expectation (Mbps)
Clients / airtime / affected peers

Rule of thumb: signal ≥ -67 dBm, SNR ≥ 25 dB, CCQ ≥ 85%, active PHY ≥ 50% of a comparable healthy PHY baseline clear those individual checks only. Marginal bands start at -75 dBm, 15 dB, 60% and 25%; values below those are poor. These are not vendor limits or installation targets. Missing data stays unknown. Do not substitute subscription speed for PHY expectation or CCQ for airMAX quality.

3. Choose the next check

4. Change once, verify, hand over

Approved action / window / original settings / recovery path:

After-change wired service, RF readings and peer impact / revert if worse:

Result / unresolved evidence / next owner and follow-up time:

Wireless link and sector verdicts in the ISPAgents UI are planned. MikroTik RouterOS REST and SNMP operations are guided pilot capabilities; this worksheet does not establish airMAX integration support.